| |
|
 |
Unifit connects metric MDPE pipe to a variety of existing pipe
materials with one fitting.
The Brett Martin Plassim range includes Unifit couplers and
elbows as standard fittings. However, for easy conversion on
site, the Unifit Kit allows a range of standard fittings to be
converted as required.
Very Convenient
Unifit's compact profile and semi-pushfit installation make
working in tight spaces easy. No need to remove the nut before
installation.
Reliable
Unifit effectively seals pipe joints. Built to withstand high working
pressures, Unifit is designed for pipe pull-out prevention. Unifit
is a long lasting fitting, manufactured from WRc approved
materials.
Modular
Unifit transition fittings are available in complete coupling units,
or as an insert conversion kit for in site upgrading of existing fittings.
So take Unifit to your next emergency or installation job for easy,
reliable and worry-free results! Unifit
Unifit Conversion Kit Assembly
Simply remove the standard nut, grip ring and seal and insert the
conversion kit components as shown. Then follow the simple installation
procedure shown below. Only the outside diameter of the existing pipework
is critical and therefore the need for numerous colour coded adaptors
is eliminated.
Technical Specifications
Unifit Installation Instructions
Instructions for assembly of Standard Fittings
 |
1. Cut the Pipe Square and de-burr.
Ensure pipe is clean and remove any loose material |
2. Loosen nut close to end of thread but do not remove |
3. Mark Insertion depth on spigot and of pipe and isert
pipe liner. |
4.Push pipe firmly past sealing ring to insertion depth |
5. Hand tighten nut to complete connection. |
|
* Brett Martin recommends the use of pipe liners when
making all joints. Chamfering and lubricating the pipe end, especially
in the larger sizes, eases the jointing process further.
Technical Specifications
DIAMETER
RANGE |
NOMINAL
PRESSURE |
|
|
|
MAXIMUM
WORKING TEMPERATURE |
|
|
WORKING
TEMPERATURE |
WORKING
PRESSURE |
|
|
|
|
|
|
|
|
