| |
|
|
|
|
|
|
Fire Performance
|
|
Light Transmission (%)
|
|
|
|
|
Cold Curving
Marlon FS can easily be cold curved. At low radii high stresses are built up in the material which will lower chemical resistance. Radii should be as large as possible to minimise stresses. The minimum allowable radius for cold curved applications is SHEET THICKNESS x 150. This incorporates a factor of safety to cope with the stress effects produced by curving and environmental stress factors.
Bonding
The material can be bonded using one of the following adhesives; Epoxy, Polyurethane, Hot Melt or Silicone. Ask your adhesive supplier for the most appropriate type of adhesive for your particular application. Solvents such as Methylene Chloride give a good bond but can lead to stress cracking and are therefore not recommended.
Cleaning
A mild detergent with lukewarm water and a soft cloth or sponge should be used to clean Marlon FS. Always rinse thoroughly with clean water. Ethyl Alcohol can be used to remove paint and other such substances. This should always be washed and rinsed thoroughly afterwards. |
| |
 |
|
|
 |
|
View
Images by Product
|
|
|
|
